Kayıt Tarihi: 27-Aralık-2017
As a relatively common machine in our daily office, the
|Gönderen: 27-Aralık-2017 Saat 10:47 | Kayıtlı IP
presence of a printer is very important in the modern
office. The frequency of using printers in our office every
day is also very high. There are many brands in the
printer, we can see a lot of brands, but the HP printer is
a relatively good brand. Not only the quality and
stability, but also the printing effect is very good. But
after some time of use, we need to fill in powder. Under
normal circumstances can be poured once the number of
sheets of paper to print is 2000 to 3000. So how to add
powder for HP CF500A?
When we carry out the https://www.v4ink.com/HP-CF500A-
Black-Compatible-Toner-Cartridge HP CF500A plus powder need
to make sure that the toner inside the cartridge has been
used up, in addition we also need to prepare some tools.
Tools have sharp-eared pliers, the corresponding type of
toner, some used newspapers, a relatively small toner
fountain, there are tools that can be used to clear and so
HP CF500A plus powder steps
The first step is to remove the cartridge from the
print cartridge and place
it in the newspaper we prepared. Pay attention to the
newspaper laying on the desktop or on the ground, so that
the toner will not fall on the desktop. This filling powder
is relatively clean.
The second step is we use tools to open the cartridge cover
of the toner cartridge, toner fountain on the corresponding
toner port, and then the toner into the toner cartridge.
When filling, we need to pay attention to slowly pouring
into, because a lot of powder filling may cause the powder
spill, resulting in waste. At the same time the powder will
pollute the environment.
The third step is when we finish filling powder, you need
to close the toner cover, the method is the same with the
open. Then we flatten the drum to shake evenly. In general,
shaking a few times you can make the toner inside the toner
cartridge evenly distributed.
The fourth step is check for the toner cartridge after
filling the powder we need to wipe the surface of the toner
by hand paper, and then check there is no leakage of the
situation. If there is timely replenishment.